Hummer H3 model years,, and

Use J for /8" ID. Used to remove and install the rear output shaft bearing without removing and disassembling the transfer case. Once the driveshaft is removed, the tool is expanded into the bushing, and its forcing screw is tightened against the output shaft to remove the shrubdisposal.bar: SPX/Bosch (OTC Rotunda Kent-Moore Miller).

If I was only going to use it once or twice I might try the cheaper tool but it better be a lot cheaper in price because from what I can see it is a lot cheaper in construction.

Made in the USA! Easy removal and installation of the extension housing bushing, without removing the extension housing. For use on these Transmissions: GM,R, GM Borg-Warner T5 (Tremtec T-5) (World-Class T-5) For removing bushings with a minimum ID of" and a maximum OD of".

Maximum shaft diameter is"/5(12). Removes transmission extension housing bushing. The tool is inserted through the bushing and the drive screw is tightened to draw the bushing out of the housing.

I have used many that look like the Miller transfer case tool.

" ID with" OD at the pulling teeth. Similar to Applications include Ford Ranger transmissions: 4R44E/5R44E; 5R55E; A4LD; C3; T5OD; 6F35; 6F Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car. Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools.

Jun 15, The new bushing goes in just fine with a mallet and the tool. MBM GTO: 17 psi LSA supercharged, forged pistons and rods, LSA heads, //LSA,E85 # FID injectors, Transmission output shaft bushing removal tool RST and magnaflow mufflers. 42RLE 4X4 Output Shaft Removal Tool TAC Dodge JeepAdd to cart; 4L30E Pump Alignment Tool Number TBAdd to cart; 4L80E Tool, Forth Clutch Piston and Housing Lip Seal ProtectorsAdd to cart; 4L80E Tool, Intermediate Clutch Piston CompressorAdd to cartImages.

Apr 30, Bloomington, MN. KD Tools makes a tool for this. (#) (Don't know if it's still available or not. I got one on ebay years ago.) You can use it to pull and replace the tail shaft bushing. Makes it a 5 minute job. maverick said: place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is.